Need Help on Altera Flex10kE configuration - Electronic Circuits Projects Diagrams Free

photis · 29th February 2004, 08:05 AM

Hi! I'm new in the forum, and I could really use some help. Currently I'm working on a project using Altera FPGA's and I need to configure these devices using the Altera EPC2 configuration Device. Up to now, I have been programming the Fpga using a JTAG configuration cable and it has worked fine. But I had to reprogramme it each time I powered up the system. I have added an EPC2 device on my design, and copied the configuration circuit from the altera datasheet and application notes, however it doesn't seem to work. I have conducted a number of experimnets using a Logic Analyser and came to find out that the EPC2 device doesn't work according to the spec. Is anyone here aware of certain bugs regarding this device or any errors on its datasheets?
Many thanx.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

29th February 2004, 08:05 AM	(permalink)
photis	Need Help on Altera Flex10kE configuration Hi! I'm new in the forum, and I could really use some help. Currently I'm working on a project using Altera FPGA's and I need to configure these devices using the Altera EPC2 configuration Device. Up to now, I have been programming the Fpga using a JTAG configuration cable and it has worked fine. But I had to reprogramme it each time I powered up the system. I have added an EPC2 device on my design, and copied the configuration circuit from the altera datasheet and application notes, however it doesn't seem to work. I have conducted a number of experimnets using a Logic Analyser and came to find out that the EPC2 device doesn't work according to the spec. Is anyone here aware of certain bugs regarding this device or any errors on its datasheets? Many thanx. __________________ We \'re all in this together...