have a little problem with the circuit
i followed the hardware page and patch up the circuit,
however the circuit is unable to reflect any wave form..
no signal have been receive at the receiver end..

what might be the problem? is there any simplified version??

i had upload the board print screen
i had added 74LS14 ic in both board, but both can't work..

http://www.geocities.com/demo080319/diagram.JPG

http://www.geocities.com/demo080319/diagram2.JPG

this is the 2 printscreen ~

Thanks for much,
piggy-

 

Could you post a schematic?

__________________
Bill
Smart Kits build Smart People
http://www.blueroomelectronics.com

 

its difficult to analyse the circuit without the schematic... pls post it....

 

http://www.geocities.com/demo080319/schematic1.jpg
http://www.geocities.com/demo080319/schematic2.jpg

i just uploaded the schematic diagiam

 

Your schematic has only five connectors and three capacitors.
It does not have a receiver circuit, does not have a 74LS14 IC and does not have a power supply.

__________________
Uncle $crooge

 

there is power supply ~

http://www.geocities.com/demo080319/schematic3.jpg
i uploaded the detailed schematic diagram ~

 

Your receiver does not have a part number.
Your power supply does not have a voltage.
Your 74LS14 does not have any Schmitt-trigger inverters.

Is the output of the 74LS14 always high or always low?

__________________
Uncle $crooge