Hi,

I am building new corvette tail lights and have designed a small circuit and circuit board was wondering if somone more knowageable than me would look it over and give me pointers. The new tail light will spell VETTE in each fixture, when the tail light is on I wish to have the intensity less than when the brake/signal lights are on. When the brake is used, the VETTE lights more intense, when the turn signal is on, the VETTE will flash in sequence....perhaps 10Hz. I threw in a 36 ohm load for the flasher to work, but if I use this sequencer, I would have to replace the flasher with a relay? I know leds current to brightness is not linear, but I was hoping they would trigger at two distinct brightness levels...perhaps some feedback could help...see sketch
:idea:
Mark W
http://www.hvacengineering.net/corvette
tailcircuit.pdf
tail_light_circuit_board.pdf

 

It's difficult to critique when your schematic and layout don't match.