help with hunter thermostat - Electronic Circuits Projects Diagrams Free

jamsinwisc · 19th February 2008, 06:01 AM

We just purchased a hunter thermostat and we have 5 wire red,green,white,blue,and yellow the thermostate has 6 spots G,RC,RH,YO,WB,Y1..the kit also includes a jumper wire.... Can any body help me put this together?

mvs sarma · 19th February 2008, 06:15 AM

Quote:

Originally Posted by jamsinwisc

We just purchased a hunter thermostat and we have 5 wire red,green,white,blue,and yellow the thermostate has 6 spots G,RC,RH,YO,WB,Y1..the kit also includes a jumper wire.... Can any body help me put this together?

See the link below -- they have all the instruction manuals-- perhaps it might serve your needs.

http://www.noblewinds.info/Hunter/Th...erThermIns.htm

0RESET0 · 19th February 2008, 06:58 PM

I hope you haven't removed the old one already. If you didn't, just match where the wires were going. The old t-stat should be labeled similarly to the new one, They are all basically the same. If you have already removed the old t-stat, or this is a new installation, then just follow directions that are available at the link above.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Title	Starter	Forum	Replies	Latest
Arduino Thermostat	prock	Electronic Projects Design/Ideas/Reviews	2	21st April 2008 04:34 PM
differential thermostat circuit	chrissmiff	Electronic Projects Design/Ideas/Reviews	8	2nd December 2007 11:39 PM
Updated today the Cricket Communicating Thermostat	William At MyBlueRoom	Electronic Projects Design/Ideas/Reviews	0	6th April 2006 05:44 AM
Thermostat	kwon	General Electronics Chat	4	16th March 2006 11:49 PM

19th February 2008, 06:01 AM	(permalink)
jamsinwisc	help with hunter thermostat We just purchased a hunter thermostat and we have 5 wire red,green,white,blue,and yellow the thermostate has 6 spots G,RC,RH,YO,WB,Y1..the kit also includes a jumper wire.... Can any body help me put this together?

19th February 2008, 06:58 PM	(permalink)
0RESET0	I hope you haven't removed the old one already. If you didn't, just match where the wires were going. The old t-stat should be labeled similarly to the new one, They are all basically the same. If you have already removed the old t-stat, or this is a new installation, then just follow directions that are available at the link above.