Help with a Buried Wire Fence - Electronic Circuits Projects Diagrams Free

billericayboy · 9th February 2007, 12:36 AM

Hi, i am looking at the buried wire fence problem for my mower-bot and have found the following schematic but am not practiced at biulding citcuits.

Can anyone give me advice on making it and getting it to work.

http://www.betuwe.net/~mowbot/UDO5transSch.PDF
http://www.betuwe.net/~mowbot/UDO5recvRcv.PDF

The idea is that you have a wire under the lawn and the robot goes up to it and then turns around and goes in another direction without crossing it. In another mode it will follow the wire to around the preimeter to cut the edge.

Any help would be apreciated.

Richard - UK

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Title	Starter	Forum	Replies	Latest
radio fence and RF sheilding	justDIY	General Electronics Chat	13	23rd September 2006 11:54 PM
Req: simple low drop constant current source	Dominique	General Electronics Chat	10	9th February 2006 03:20 PM
Electric fence doesn't work?	teslatower	General Electronics Chat	46	3rd June 2005 06:31 PM
Winding coupled inductors	evandude	General Electronics Chat	2	5th April 2005 05:50 PM
Switcher CAD III help	zachtheterrible	General Electronics Chat	6	1st August 2004 02:04 AM

9th February 2007, 12:36 AM	(permalink)
billericayboy	Help with a Buried Wire Fence Hi, i am looking at the buried wire fence problem for my mower-bot and have found the following schematic but am not practiced at biulding citcuits. Can anyone give me advice on making it and getting it to work. http://www.betuwe.net/~mowbot/UDO5transSch.PDF http://www.betuwe.net/~mowbot/UDO5recvRcv.PDF The idea is that you have a wire under the lawn and the robot goes up to it and then turns around and goes in another direction without crossing it. In another mode it will follow the wire to around the preimeter to cut the edge. Any help would be apreciated. Richard - UK