Hello all,

For energy calibration in my Energy meter project,
I plan to do this.....

I will have optical fibres connected to the CF output of
i) Standard energy meter ii) energy meter under test.
The two mwters will be connected to the same load.

[ CF output : Calibration frequency, An LED is provided for energy meter
which will blink with a frequency proportional to the Energy]

So i will be getting optical signals.
I have to convert them to pulses.

I have planned to design a micro-controller based design,
which will act as pulse counter. I have a timer which will run for a specified
interval of time. After that time is elapsed,
I will observe the pulses recorded.
Based on m,y observation i will calibrate the offset in MY energ meter.

So, i ...............
Need a circuit which will convert optical signals to pulses.
Please help me out.
Also tell me if there are any products readily available in market.

Thanking you
Venkatesh T.K

 

An LDR + transistor ??

 

The circuit is quite simple:

Attached Images

photo_detector.png (7.0 KB, 111 views)

__________________
see my website: www.geocities.com/russlk