Manual or schematic diagrams wanted: AEG Microverter_D 10.5/380 - Electronic Circuits Projects Diagrams Free

tonigau · 18th February 2009, 11:02 PM

HI,

I am looking for a operator manual (or any info ) on a AEG Microverter_D 10.5/380 Variable Speed Drive.

This is a 3 phase motor drive (10,5kW ?) 380V.

I think Alstom took over this division of AEG some time ago.

Thanks

tonigau · 20th February 2009, 03:21 AM

I found a user Manual today. (Alstom)

I Don't expect to find a circuit diagram....

I want to operate this on single phase 230Vinput, Intended Motor is 3ph 0.5KW. As this is a 3ph 380V(415V) input unit I might build up a mains voltage doubler, easier than modifying the Vin sense & logic supply without a diagram but then I wont know untill I investigate. least I've got 2 options

Should be plenty of existing DCbus capacitance (3ph --> 1ph in) considering it is a 10.5KW unit & my motor is 0.5kW (old hercus lathe)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar
Title	Starter	Forum	Replies	Latest
Wanted: Service manual Beckman 9204	RussMartin	Datasheet/Parts Requests	0	7th August 2008 11:41 PM
WANTED: Wavetek Model 75A Service Manual	Ratinoff	Datasheet/Parts Requests	2	1st August 2008 05:28 AM
PIN DIAGRAMS WANTED	buland	General Electronics Chat	1	7th May 2005 02:53 PM
WANTED! Grundig MO-53, or MO-22 schematic	oldmp	General Electronics Chat	3	14th June 2004 11:33 PM
Schematic Diagrams	Nica	Datasheet/Parts Requests	1	17th June 2003 01:08 PM

18th February 2009, 11:02 PM	#1
tonigau	Manual or schematic diagrams wanted: AEG Microverter_D 10.5/380 HI, I am looking for a operator manual (or any info ) on a AEG Microverter_D 10.5/380 Variable Speed Drive. This is a 3 phase motor drive (10,5kW ?) 380V. I think Alstom took over this division of AEG some time ago. Thanks

20th February 2009, 03:21 AM	#2
tonigau	I found a user Manual today. (Alstom) I Don't expect to find a circuit diagram.... I want to operate this on single phase 230Vinput, Intended Motor is 3ph 0.5KW. As this is a 3ph 380V(415V) input unit I might build up a mains voltage doubler, easier than modifying the Vin sense & logic supply without a diagram but then I wont know untill I investigate. least I've got 2 options Should be plenty of existing DCbus capacitance (3ph --> 1ph in) considering it is a 10.5KW unit & my motor is 0.5kW (old hercus lathe)