|
|
|
|
|
 |
 |
 |
 |
|
|||||||
| Datasheet/Parts Requests Request a datasheet or enquire about part equivalents and/or difficult-to-find parts here. |
 |
|
|
Thread Tools | Display Modes |
8th August 2006, 05:14 PM
|
(permalink) |
Help Needed!!! Print my circuit on PCB!!!
I will be designing my own circuit with circuit maker.....any one from 'MALAYSIA' knows where i can get my circuit printed on a PCB!!! how much isit????
|
|
|
|
|
8th August 2006, 06:26 PM
|
(permalink) |
|
if you looked at the top of the page on this forum, you would see an advertisement banner:
http://pagead2.googlesyndication.com...554790474&nm=6 |
|
|
|
|
|
12th August 2006, 05:46 AM
|
(permalink) |
|
We use to make a Negitive of the circuit pattern on a coppier with clear plastic film and use Photosensitive solution on the copper in a Darkroom and expose it to light then soak it in the etching solution. And like Magic we could watch the circuit appear before our eyes on the board.
Check this out CLICK HERE http://zeus.eed.usv.ro/misc/mirrors/cc/pcbfaq.htm Last edited by hotwaterwizard; 12th August 2006 at 05:56 AM. |
|
|
|
|
|
12th August 2006, 12:08 PM
|
(permalink) |
|
You can easilly make PCBs using copper clad board, magazine paper and a laser printer.
http://www.freepcb.com/downloads/pcb-0.0.2.pdf http://www.fullnet.com/u/tomg/gooteepc.htm http://www.webelectricproducts.com/98/3/etch.htm
__________________
I also post at the following sites: http://www.stop-microsoft.org http://www.heated-debates.com Screen name: Aloone_Jonez |
|
|
|
|
Linear Mode
