mashersmasher

so i was thinking. i have this plastic mesh that adheres to it's self amazingly when heated with a heat gun since it's practically made out of the same stuff hot glue sticks are (i can even cut it into strips and use it in a glue gun). so what i was thinking is that if i had some really heat resistant gloves that could withstand up to about 100+C then one could practically mold this stuff into whatever frame they needed and have a light frame that's half the weight of fiberglass.

3v0

The people who do metal casting have heat resistant gloves. They used to be asbestos, I am not sure what they were replaced with.

Could you just rotate the frame and slump the web over the frame with the heat gun ?

__________________
search engine for electronic parts
Junebug USB PIC programmer kit., USB Bit Wacker, Homepage
The 15 Minute Printed Circuit Board! (+drill time)

jpanhalt

Harbor Freight has them, I think. Nomex comes to mind as the material in US-made gloves. Not sure of the imports. Kitchen supply places also have them. John

JimB

Have a look in a good tool suppliers, they will have welders gloves/gauntlets, no problem at 100+ degC, but they may be a bit unweildy (sp?) and thick.
They are usually made of leather and proof against brief contact with red hot steel.

JimB

__________________
Experience is directly proportional to the value of the equipment ruined.

Nigel Goodwin

Years ago we absailed off an old railway viaduct

http://www.monsalhead.com/graphics/viaduct.jpg

We went down the middle of the arch to the right of the river (actually on the far side of this picture), from the top of the arch to the ground is about 90 feet. One of us actually worked at a factory where they make bricks, so he borrowed a pair of asbestos gloves - and we did the full distance in one single drop, braking desperately at the bottom with the glove protecting your hand!. Then, VERY quickly, you unclipped the figure 8 descender off the rope, and dropped it in the river to cool - as it was hot enough to melt the rope

Now they have signs up saying "no absailing", but back then no one had thought to ban it!.

__________________
PIC programmer software, and PIC Tutorials at:
http://www.winpicprog.co.uk

mashersmasher

wow that sounds cool

Krumlink

Ove Gloves!

"High tec silicon compound"

http://www.rkdm.com/oveglove/

__________________
MechTronics

Bob Scott

I would not trust oven mitts with my life. Can you imagine what will go through your head as the silicon oven mitts disintegrate as you rappel down a cliff?

jpanhalt

According to the ad, they are made of Kevlar and Nomex and have silicone stripes for added gripping friction.

John